Return to Main Page
« Panasonic PVGS120 3CCD MiniDV Camcorder
Using integers in a C++ ArrayList »

Samsung TXN3245FP X11 Modeline

After many hours of learning and playing with Powerstrip, I have finally gotten a resolution and timing that works well with my TV.

This is obviously a very obscure post, however, I wish it was out there when I was looking for it. If you happen to have a Samsung TXN3245FP with 1080i support enabled, then this may be of interest.

I’ve got my MythTV box hooked up to my TV via the VGA port through a VGA to component transcoder. In order to do that, X11 needs a custom ModeLine to setup the resolution and timing parameters. So, below is the ModeLine that I got to work with my TV. However, these parameters can be device specific, but this should give you a place to start if you’ve got the same TV. Good luck!

# 540p for Samsung TXN3245FP
ModeLine “704×489″ 30.587 704 736 808 912 489 518 521 559 +hsync +vsync

This entry was posted on Sunday, March 13th, 2005 at 10:32 pm and is filed under Home Theatre PC. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.

2 Responses to “Samsung TXN3245FP X11 Modeline”

  1. henri Says:
    May 7th, 2005 at 11:25 am

    shoot, can’t turn on 1080i on mine :(

  2. Ilya Shubin Says:
    May 14th, 2008 at 5:37 am

    Ultimately though, it’s not the Gateway that does it for the X11, it’s Samsung’s own Q35. This essentially offers the same specs as the X11 but in a smaller, lighter package but with better battery life

Leave a Reply